Electronics LP2000_VAR Manual de usuario descargar pdf (Pagina 7)

Fig. 10 The adapter plates should be

preinstalled onto the MagnaValve and

the assembly installed as a single unit,

The entire MagnaValve assembly can

be temporarily positioned and held into

place by using vise-grip or similar pli-

ers and then the bolts can be installed

and tightened.

Fig. 11 The feed spout can now be rein-

stalled easily, since it bolts directly to the

special adapter plate. Be sure to use a

rubber gasket between the adaptor plate

and the feed spout. Do not use silicon rub-

ber or any other adhesive that will make it

difficult to remove the valve for inspection.

Fig. 10

Fig. 11

Note:Adding a nonmetallic 1” spacer

above and below the Magnavalve will

significantly improve MagnaValve per-

formance.

1 2 3 4 5 6 7 8 9 10 11 12 13

Sin comentarios

Electronics LP2000_VAR Manual de usuario Pagina 7